Yamaha VS-10 Service Manual page 16

VS-10/NX-SW10
DSP FULL BIT
The main L/R is input through AC3D2av to DSP and then output through all
channels. The same applies as "YSS918" except that the digital data is output in
full bit at D/A.
VIDEO2 IN :
VOLUME :
CB306 (Page E-31, F-3)
MAIN L (1kHz) :
MAIN R (1kHz) :
LFE (30Hz) :
REAR L (1kHz) :
REAR R (1kHz) :
CENTER (1kHz) :
3. AC-3/dts Through
Only the signal of the digital system is input. The AC3 signal is decoded and reproduced according to
the input source.
The AC-3 signal in each channel is AC-3 decoded and output through AC3D2av.
The combined status information of the sampling frequency and the number of chan-
nels of the AC3 signal appears on the Fl display.
ANALOG IN
DIGITAL IN
Status information
AC3 48k 3/2
Sampling frequency
15
– 20dBV, Both ch
MAX
– 11dBV
– 11dBV
– 13dBV
– 17dBV
– 17dBV
– 17dBV
CODEC.AD AC3D2av(YSS918)
CS4227
DECODER
DOLBY DIGITAL
DIR2
or
PRO LOGIC
or
DTS
YM3436
Number of channels
DSP
L/R L/R
CODEC.DA
C/LFE C/LFE
LS/RS LS/RS
CS4227
256K SRAM
The shaded square means that the element included in it does not operate.
Sampling frequency (Display)
Analog Analo
32kHz 32k
44.1kHz 44.1k
48kHz 48k
MAIN L
MAIN R
CENTER
LFE
REAR L
REAR R
Number of channels
(Front/Rear) (Display)
1+1 1+1
1/0 1/0
2/0 2/0
3/0 3/0
2/1 2/1
3/1 3/1
2/2 2/2
3/2 5.1ch 3/2
7.1 (DTS) 7.1