Dsp Diag Mode (Self-Diagnosis) - Yamaha VS-10 Service Manual

DSP DIAG MODE (Self-diagnosis)

Use the remote controller supplied as an accessory to select the menu.
1. Procedure for starting DSP DIAG
Referring to TEST PROGRAM MODE in the previous section, select/execute "05 DSP Diag".
When "05 DSP Diag" is executed, the current input name appears on the display followed by "Sel.1to9 Key".
2. Procedure for selecting Main menu and Sub-menu
Using [1] through [9] keys on the remote controller, select the main menu. Soon the sub-menu will appear on the display.
Then, select the sub-menu. Every time the selected key (on the remote controller) is pressed, the sub-menu on the display
changes.
No. Main menu
1 Analog through
2 DSP through
3 AC-3/dts through
4 Pro logic
5 Speakers set
6 Effect off
7 Manual test
8 No function
9 DIAG cancel
3. Procedure for canceling DIAG
There are two methods for cancellation of DIAG.
a. Turn off the power by pressing the [POWER] key of the main unit or the remote controller.
b. Press the [9] key of the remote controller. (The normal mode will be restored.)
(Display) Sub-menu
Analog Thr.
MAIN BYPASS
DSP 0dB
Dsp Through
YSS908-SRAM
YS908
DSP FULL BIT
AC-3/dts Thr.
Status (Binary)
Pro Logic
CENTER LARGE
EFFECT OFF
Speakers Set MAIN : SMALL 0dB
MAIN : LARGE 0dB
LFE/BASS : MAIN
CENTER : NONE
LFE/BASS : MAIN
LFE/BASS : SWFR
CENTER : NONE
CENTER : SMALL
REAR : SMALL
Effect Off
EFFECT OFF
Manual Test ALL
MAIN L
CENTER
MAIN R
REAR R
REAR L
LFE
VS-10/NX-SW10
(Display)
A.T.M.Bypass
A.T. DSP 0dB
DspT.908SRAM
DspT.YSS908
DspT.FullBit
Analo2/0
ProL.CenterL
ProL.Eff.Off
Sp.MainS 0dB
Sp.MainL 0dB
Sp.Lfe:M C:N
Sp.LfeBass:M
Sp.Lfe:Swfr
Sp.Cent:None
Sp.Ce:S Re:S
Effect Off
M.Test All
M.Test Left
M.TestCenter
M.Test Right
M.Test RearR
M.Test RearL
M.Test Lfe
12