Wireless Equipment - Denso BHT-700BB-CE Operator's Manual

Wireless Equipment

● Precautions relating to the frequency used by this device
In addition to industrial, scientific, and medical equipment such as microwave ovens,
static wireless stations (permit required) used for mobile identification in places
such as plant manufacturing lines and specified low-power wireless stations (no
permit required) operate on the same frequency band as this device.
1. Before using this device, ensure that no static wireless stations or specified
low-power wireless stations for mobile identification are being used in the vicinity.
2. In the event of instances of electromagnetic interference from this device to a
static wireless station being used for mobile identification, either promptly alter the
usage frequency, or halt the electromagnetic discharge
3. If other problems arise due to reasons such as electromagnetic interference from
this device to a specified low-power wireless station being used for mobile
identification, please contact DENSO WAVE through QBnet (see page iv).
4. This device is equipped with an international roaming function (IEEE802.11a/b/g)
that allows suitable channels to be selected within specific countries (excludes
the BHT-710BB-CE).
5. Set the country using the access point prior to use. Setting to a country other
than that in which the device is used may be considered a violation of the law
(excludes the BHT-710BB-CE).
● Requests to system designers
• Communication may not be possible depending on the environment in which the
device is being used. Ensure that problem-free communication is possible prior to
use.
• Use a program capable of retransmitting data if communication fails.
• If the BHT is introduced into an environment in which a device using 2.4/5.0GHz
waveband electromagnetic waves is operating, or if a another device using
2.4/5.0GHz waveband electromagnetic waves is introduced following introduction
of the system, run all devices and ensure that communication with the BHT is
possible prior to use.
• Check communication once again prior to use if any changes are made to the
usage environment (addition of household appliances, movement or addition of
shelves, equipment and so on) following introduction of the system.
3