Sony HVR-M10C Service Manual page 322

2-2-2. INITIALIZATION OF 8, C, 13, 18, 1C PAGE DATA
< Changed contents (Page 6-58) >
2. Modification of 8, C, 13, 18, 1C Page Data
If the 8, C, 13, 18, 1C page data has been initialized, change the
data of the "Fixed data-2" address shown in the following table by
manual input.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) When changing the 8, C page data, select page: 0, address: 10,
and set data: 00.
3) When changing the 13, 18, 1C page data, select page: 0, address:
10, and set data: 01.
After completing the modification of 13, 18, 1C page data,
reset the data of this address to "00".
4) New data for changing are not shown in the tables because
they are different in destination. When changing the data, copy
the data built in the same model.
Note: If copy the data built in the different model, the camcorder may
not operate.
5) When changing the data, press the PAUSE button of the
adjustment remote commander each time when setting new
data to write the data in the non-volatile memory.
6) Check that the data of adjustment addresses is the initial value.
If not, change the data to the initial value.
Processing after Completing Modification of 8, C, 13, 18, 1C Page data
Order Page Address Data
1 0 10
2 2 00
3 2 01
Version check of the mechanism control microprocessor:
(VC-367 board IC8801)
Order Page Address Data
1 0 10
2 3 FF
HVR-M10C/M10E/M10J/M10N/M10P/M10U
Procedure
00 Set the data.
29 Set the data.
29 Set the data, and press PAUSE
button.
Procedure
00 Set the data.
The data shows the version of the
mechanism control microprocessor.
40: Ver. 4.0 (MP4)
50: Ver. 5.0 (MP5)
60: Ver. 6.0 (MP6)
70: Ver. 7.0 (MP7)
80: Ver. 8.0 (MP8)
— 8 —
: Added portion