Sony HVR-M10C Service Manual page 181

1-3-27. TG2 Cam Plate Assy (N)
1. Removal procedure
1) Remove the LS guide roller (S1) 1 from the S1 shaft.
2) Remove the LS guide roller (S2) 2 from the S2 shaft.
3) Release the claw A of the TG2 cam plate assy 3 from the
right groove B of the mechanical chassis.
4) Remove the TG2 cam plate assy 3 in the direction of the arrow
C.
Apply Grease
Points to be noted
Apply grease when installing it.
Amount of grease: a ball of 1.0 mm
diameter of grease
LS guide roller S1, S2
Apply grease
3 TG2 cam
1 LS guide roller S1
Brake driving arm (N)
S2 shaft
S1 shaft
Apply Grease
Points to be noted
Apply grease when installing it.
Amount of grease: a ball of 1.0 mm
diameter of grease
S1 shaft, S2 shaft
HVR-M10C/M10E/M10J/M10N/M10P/M10U
Apply grease
2 LS guide
C
roller S2
plate assy
D
Two round
holes E
Groove B
Apply grease
2. Attachment procedure
1) Move the brake driving arm (N) of the TG2 cam plate assy (N)
3 in the direction of the arrow D, and move the TG2 driving
arm (N) in the direction of the arrow E.
2) Insert the right claw A of the TG2 cam plate assy (N) 3 into
the right groove B of the mechanical chassis first.
3) Install the two round holes E of the TG2 cam plate assy (N)
3 into the S1 shaft and the S2 shaft.
4) Move the brake driving arm (N) in the direction of the arrow
G, and move the TG2 driving arm (N) in the direction of the
arrow H at this time align the grooves of the arms and the
shafts.
5) Apply grease in the I portion of the TG2 cam plate assy.
Amount of grease: a ball of 1.0 mm diameter of grease
6) Apply grease to the TG2 driving shaft.
Amount of grease: a ball of 2.0 mm diameter of grease
7) Apply grease to both sides of the S1 shaft and the S2 shaft.
Amount of grease: a ball of 1.0 mm diameter of grease
8) Apply grease to both sides of the LS guide roller S1, S2.
9) Install the LS guide roller S1 1 in the S1 shaft.
10) Install the LS guide roller S2 2 in the S2 shaft.
TG2 CAM PLATE ASSY (N)
The Points
in Re-assembling
TG2 driving
S2 shaft
arm (N)
Claw A
E
Brake driving
arm (N)
S1 shaft
• The arms must not override on the shafts.
• The arms must not be deformed.
• Confirm that the right and left claws of the TG2
cam plate assy 3 have entered into the
mechanical chassis surely.
Apply grease when installing it
I
Amount of grease: a ball of
1.0 mm diameter of grease
6-38
TG2 driving arm (N)
TG2 cam
plate assy (N)
H
Claw A
TG2 driving
shaft
G
Brake driving
shaft (roller)
TG2 driving arm (N)
Apply grease when installing
it Amount of grease: a ball of
2.0 mm diameter of grease
TG2 driving
shaft
Brake driving
shaft (roller)