Sony HVR-M10C Service Manual page 159

1-3-6. MIC Terminal (MIC902)
1. Removal procedure
1) Remove soldering at the five locations A, and remove the FP-
826 flexible board 1 from the MIC terminal (MIC902) 3.
Remove the screw (special head screw M1.4 × 2.0) 2 and
2)
remove the MIC terminal (MIC902) 3.
Soldering
Points to be noted
Use the rubber finger tip cover
Lead-free solder
Wire type
Soldering iron
Soldering iron tip
Temperature of the
soldering iron tip
Contacting time of
soldering iron tip
HVR-M10C/M10E/M10J/M10N/M10P/M10U
FP-826 flexible board
1
MIC terminal (MIC902)
Soldering at the five locations A
: ∅ 0.6
: 941 made by Hakko
: T1-1BC
: 300 ± 10 ° C
: within 2 sec
2. Attachment procedure
1) While pressing the top of the MIC terminal (MIC902) 3,
tighten the two screws (special head screw M1.4 × 2.0) 2 in
the order of B then C.
Tightening torque: 0.059 ± 0.01N•m (0.6 ± 0.1kgf•cm)
2) Make soldering at the five locations A, and connect the FP-
826 flexible board 1 into the MIC terminal (MIC902) .
2 Two screws
(M1.4 × 2.0)
3 MIC terminal
(MIC902)
C
FP-826 flexible board
6-16
B