Bock Water heaters 30ST Instruction Manual

Bock Water heaters 30ST Instruction Manual

Storage tanks

Advertisement

To the Installer:
Please attach these instructions
next to the water heater.
WARNING
Improper installation, adjustment, alteration,
service or maintenance can cause serious
injury or property damage. Refer to this
manual. For assistance or additional
information, consult a qualified installer or
service agency.
CAUTION
The recommended temperature for normal
residential use is 120°F. The dial on the aquastat
does not always reflect the out-coming water
temperature and it could occasionally exceed
120°F. Variation in outcoming temperature
could be based on factors including, but not
limited to, usage patterns and type of
installation. Test water at the tap nearest to
the water heater and storage tank.
WARNING
Hotter water increases the risk of scald injury.
Before adjusting the water temperature setting,
read this instruction manual. Temperatures at
which injury occurs vary with the person's age
and the length of exposure. The slower
reaction time of children, elderly, or
physically or mentally challenged persons
increases the scalding hazard to them. It is
recommended that lower water temperatures
be used where these exposure hazards exist.
Households with small children or invalids
may require a temperature setting less than
120°F to prevent accidental contact with hot
water. To produce less than 120°F, use point-of-
use temperature limiting devices.
If higher water temperature is needed in part
of the water system, automatic temperature
limiting devices must be used on all lines to
water taps.
INSTALLER RESPONSIBILITIES
Please read all instructions before installing or
placing this storage tank into service. This
unit must be installed by licensed or
authorized installers, or technical personnel
that service water heating equipment. The
Storage Tank must be installed in accordance
with all local codes and ordinances.
23950
To the Consumer:
Please read these and all component
instructions and keep for future reference.

Storage Tanks

Instruction Manual

Warranty, Registration Card and Parts List are included.
Owner: Please remember to return the Registration Card!
HANDLING
Before uncrating, check for shipping damage.
Report any damage to your carrier. Note
damage on bill of lading or delivery receipt
and file a claim.
LOCATION
This storage tank should be located in a
central location to the piping system, as close
as possible to the heat source and in an area
not subject to freezing temperatures. Leave
sufficient space for servicing and maintaining
the tank.
WATER HEATER AND TO PROVIDE IMPORTANT
Read all instructions thoroughly before at-
tempting installation or operation of your
water heater. Keep these instructions for future
reference.
Local plumbing and electrical codes must be
followed in the installation of this storage
tank. In the absence of a local code use the
UNIFORM PLUMBING CODE and the NFPA
Code. Local codes may supersede instructions
in this installation manual.
These instructions are a guide for the correct
installation of the storage tank. The manufac-
turer will not be liable for damages caused by
failure to comply with the installation and
operating instructions outlined on the
following pages.
If you lack the necessary skills required or have
difficulty following the directions, seek help
from a qualified person for that part of the
installation you do not understand.
THIS MANUAL HAS BEEN PREPARED TO
ACQUAINT YOU WITH THE INSTALLATION,
OPERATION, AND MAINTENANCE OF YOUR
SAFETY INFORMATION.
FAILURE TO FOLLOW THESE INSTRUCTIONS
OR ALL APPLICABLE BUILDING CODES AND
REGULATIONS VOIDS THE WARRANTY ON
THIS WATER HEATER.
Rev 5 6/16

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 30ST and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Bock Water heaters 30ST

  • Page 1: Storage Tanks

    To the Installer: To the Consumer: Please attach these instructions Please read these and all component next to the water heater. instructions and keep for future reference. Storage Tanks Instruction Manual Warranty, Registration Card and Parts List are included. Owner: Please remember to return the Registration Card! HANDLING WARNING Improper installation, adjustment, alteration,...
  • Page 2 Supply/Return Conn. Aquastat Conn. Aquastat Conn. Supply/Return Conn. Supply/Return Conn. Drain Valve Drain Valve Figure 1: 30ST, 50ST Figure 2: 80ST, 119ST Table 1: ST Dimensions D i m e n s i o n s 30ST ⁄ ⁄ ⁄...
  • Page 3 Anode Rods Hot Outlet (2) NPT Connection (T&P valves NOT su ASME Rating Plate Inlet/Return Aquastat Connections Connection Cleanout Hand-ho Drain Valve Figure 3: ASME Vertical Table 2: ASME ST Dimensions 2” T&P Relief Inlet/ Overall Shipping Insulation Storage Working Overall Aquastat Model...
  • Page 4: Temperature Controls

    WHEN YOU RECEIVE YOUR NEW STORAGE TANK Check the new equipment to see if all components are in good condition. The T&P valves, aquastat and immersion well are supplied by the installer. TEMPERATURE CONTROLS Bock storage tanks are equipped with ⁄...
  • Page 5: Installation

    INSTALLATION There are many factors to consider when installing a storage tank. How will the system be used? What are the hot water demands of the system? Why is a storage tank being installed? Are the peak demands frequent such as a home with multiple showers or very intermittent such as a church kitchen? The answers to these questions will help you determine what your system should look like.
  • Page 6 DRAWING #2 The reverse storage tank system, HOT OUT drawing #2, is a variation on the typical system discussed previously and is intended for use in an installation with only occasional ON/OFF high loads. An example of this is SWITCH CIRCULATING a church kitchen that serves a PUMP...
  • Page 7: Maintenance

    DRAWING #4 Drawing #4 shows a typical system with two water heaters MANIFOLDING MUST BE COLD WATER connected in parallel EQUAL LENGTH SUPPLY supplying hot water to the storage tank which then supplies hot water to the building load. Plumbing is HOT WATER identical to the typical system shown in drawing #1 with the...
  • Page 8: What Does This Limited Warranty Cover

    LIMITED WARRANTY FOR STORAGE TANKS Bock Water Heaters, Inc. 110 S. Dickinson Street Madison, WI 53703 Phone: 608-257-2225 WHAT DOES THIS LIMITED WARRANTY COVER? This limited warranty applies only to the original consumer purchaser. General Defects and Malfunctions: This warranty covers defections and malfunctions in your new storage tank a period of one year from the original installation date.
  • Page 9 Bock Water Heaters, Inc. • 110 South Dickinson Street • Madison, WI 53703 Telephone 608 -257-2225 • Fax 608 -257- 5304 www.bockwaterheaters.com...
  • Page 10 NOTES Page 10 Storage Tanks...
  • Page 11 NOTES Storage Tanks Page 11...
  • Page 12 Storage Tanks 23950...

This manual is also suitable for:

50st80st119st

Table of Contents