Bock Water heaters 241E Installation, Operation & Maintenance Instructions Manual

Bock Water heaters 241E Installation, Operation & Maintenance Instructions Manual

Bock water heater oil-fired water heater installation, operational & maintenance manual

Advertisement

Quick Links

TO THE INSTALLER:
Please attach these in-
structions next to the
water heater.
TO THE CONSUMER:
Read these and all
component
instruc-
tions. Please keep for
future reference.
Waranty, registration card
& parts list included.
WARNING: Improper installation, adjustment, alteration,
service or maintenance can cause serious injury or
property damage. Refer to this manual. For assistance
or additional information, consult a qualified installer or
service agency.
WARNING: If the information in these instructions is not
followed exactly, fire or explosion may result and can
cause property damage, personal injury or death.
DO NOT INSTALL THE WATER HEATER ON COMBUSTI-
Install in accordance with all local
BLE FLOORING.
codes. In the absence of local codes, refer to NFPA 31
or ANSI Z21.10.1,
or contact Bock Water Heaters with
questions concerning proper flooring materials.
Minimum clearance to combustible construction is:
SIDES 6"; BACK 6"; FRONT 24". The installation of this
water heater must conform with local codes and ordi-
nances. In the absence of local codes, the installation
must comply with the National Fire Protection Associa-
tion (NFPA 31) Code.
WARNING: The recommended temperature for normal
residential use is 120
F. The dial on the aquastat does
o
not always reflect the outcoming water temperature,
110 S. Dickinson St. • P.O. Box 8632 • Madison, WI 53708-8632
Phone: 608/257-2225 • Fax: 608/257-5304 • www.bockwaterheaters.com
INSTALLATION, OPERATION
& MAINTENANCE INSTRUCTIONS
OIL-FIRED WATER HEATERS
72E • 73E • 190E • 241E • 361E • 541E
Bock Water Heaters, Inc.
which could occasionally exceed 120 o F. The variation in
outcoming temperature could be based on factors in-
cluding but not limited to usage patterns and type of
installation. Test your water at the tap nearest to the wa-
ter heater.
WARNING: Hotter water increases the risk of scald in-
jury. Before changing the temperature setting, read the
instruction manual. Temperatures at which injury occurs
vary with the individual's age and length of exposure.
The slower reaction times of children, elderly and phys-
ically or mentally impaired persons increases the
scalding hazard to them. It is recommended lower wa-
ter temperatures be used where these situations exist.
To lower water temperature use point-of-use tem-
perature limiting devices.
WARNING: Flammable vapors may be drawn to this
water heater from other areas of the structure by air cur-
rents. Do not store or use any flammable liquids in
the vicinity of this heater.
WARNING: Water heater blankets may restrict air flow
to the heater and cause fire, asphyxiation, personal in-
jury or death.
WARNING: Hydrogen gas can be produced in a hot
water system that has not been used for an extended
period–generally, two weeks or longer. To prevent pos-
sible injury under this situation, we recommend that a
hot water faucet be wide open for several minutes
before you use ANY electrical appliance that is connect-
ed to the hot water system. If hydrogen is present, an
unusual sound – such as air escaping – will come from
the open faucet as the hot water begins to flow.
Hydrogen gas is extremely flammable – there must
be no open flame near this open faucet.

Advertisement

Table of Contents
loading

Summary of Contents for Bock Water heaters 241E

  • Page 1 Please keep for future reference. Waranty, registration card 72E • 73E • 190E • 241E • 361E • 541E & parts list included. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause serious injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer or service agency.
  • Page 2 190E 241E 361E 541E 73E, 190E, 241E, 361E – 2 – stalled – do not block access to the burner, inspection door, handholes or controls. Leave room to pipe the unit and connect the fuel and electricity.
  • Page 3: Combustion And Ventilation Air

    WATER PIPING: Models 72E, 73E, 190E, 241E and 361E have polysulfone dip tubes. When using sweat fittings, do not apply heat to the nipples. Pipe hot and cold lines with a union and valve on attention to avoid each line.
  • Page 4: Electric Wiring

    Use the existing supply and return lines for the booster pump. Change the existing unit to a one-pipe system and tee off the one pipe to supply oil to the water heater. CONNECT TO Using “L”...
  • Page 5 ANODE RODS Vent system should be checked at least once a year for damage and/or blockage. If the water heater is to be shut off during cold weather, the tank and water lines should be drained to FREEZING prevent freezing and piping damage. Please see warning on hydrogen gas buildup on page 1. IMPOR- TANT! The water heater warranty will be invalid if the tank fails due to excessive pressure, the accu- mulation of lime or sediment, corrosion, or freezing.
  • Page 6 Models 73E - 541E L4080B L8106 L4006A FIGURE 6 FIGURE 5 Wayne burner Carlin burner w/ w/ Carlin EZ-Temp Carlin EZ-Temp (all models) Models 72E, 73E, Beckett burner 190E, 241E, with Carlin EZ-Temp 361E, 541E (Only 190E) – 6 –...
  • Page 7 – 7 – OIL-FIRED WATER HEATER MODELS 72E, 73E, 190E, 241E, 361E & 541E This is a tank assembly parts list. When ordering repair parts, always give the part name, heater number (size) and serial number. ITEM DESCRIPTION ITEM Cold water inlet dip tube...
  • Page 8: Burner Parts List

    THREE (3) years from the date of original installation. The company also warrants that no other part of this water heater will fail due to a defect in material or workmanship for one (1) year.

This manual is also suitable for:

361e541e72e73e190e

Table of Contents