Assembly - Gravely Zoom Bagger Owner's And Operator's Manual

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
UNPACKING UNIT
IMPORTANT: Remove contents from carton carefully.
Place cover assembly on a flat piece of cardboard to
avoid scratching it.
Package Contents:
Check the contents of your kit for the parts listed below
and shown in Figures 3 – 6.
Item Description
1 Weldment Bagger Weight Tray
2 Mesh Bag
3 Grip, Adhesive
4 Cast Iron Weight
5 5/16 x 1" Round Head Square
Neck Bolt
6 5/16-18 Nyloc Nut
7 3/8-16 x 3" Hex Bolt
8 3/8" Lock Washer
9 1/2 x 2" Round Head Square
Neck Bolt
10 1/2" Nyloc Flange Nut
11 1/2" Push Nut
12 .515 x 1.625 x .250 Flat Steel
Washer
13 .438 x 1.00 x .083 Flat Steel
Washer
14 .390 x 1.5 x .125 Flat Steel
Washer
15 Locking Bow Tie Cotter Pin
.091 x 7.875
16 Wing Knob
17 Studded Wing Knob
18 34" Boot Assembly (815040)
42" Boot Assembly (815041)
50" Boot Assembly (815042)
19 L Bracket, Brace & Hardware
20 Bagger Hose (815040)
Bagger Hose (815041, 042)
21 Hood Assembly
22 Receiver & Hardware
23 Bag Frame
24 Plastic Tube, 3/8 x 1/2 x 3"

ASSEMBLY

Qty Part
Number
1 04215451
2 03862900
1 03833800
1 00172000
2 06216100
2 06545400
2 05957800
4 06308800
2 06200205
4 06500010
2 06500705
6 06445000
INSTALL FRONT WEIGHT TRAY &
COUNTERWEIGHT
4 06435900
2 06441700
4 06700201
1 07500225
1 07500226
1 51577500
1 51577600
1 51577700
1 N/A
1 04445600
04222900
1 51577800
1 N/A
2 00663200
2 00677000
7
4
1
22
19
815041
18
Figure 3
WARNING: ALWAYS install counterweight
before operating unit with bagger attached.
ALWAYS remove counterweight when bagger is
removed from unit.
1. Remove the front footrest. There are two 1/2 x 2"
(item 9) and 5/16 x 1" (item 5) round head square
neck bolts that secure the footrest to the chassis.
The 1/2 x 2" bolts (item 9) and metal spacers are
held on the footrest by two 1/2" push nuts (item 11).
Twist or cut off the push nuts to remove. Save the
spacers and discard all other hardware. See
Figure 4.
2. Lay the footrest onto the back of the weight tray
(similar profile). It may be helpful to have the weight
tray laying upside down on the ground when mating
it to the footrest. Install two 1/2 x 2" bolts (item 9)
thru the front of the weight tray and footrest. Slide
the two spacers (from step 1) over the bolts and
secure with push nuts (item 11). Secure the push
nuts as tight as possible. See Figure 4.
21
20
815040
18
815042
23
24
2
18