Maintenance - Gravely Zoom Bagger Owner's And Operator's Manual

WARNING: NEVER open cover assembly while
the engine is running and the PTO is engaged.
ALWAYS shut off engine prior to emptying mesh
bags.
To empty grass bags:
1. Disengage PTO, stop engine, and remove ignition
key. Wait for all moving parts to stop before leaving
operator's position.
2. Disconnect latch strap and open cover and remove
each mesh bag from bagger frame.
3. Empty the grass from each mesh bag.
4. Install mesh bags back on bagger frame. Make
sure that the heat-resistant side of the mesh bags
face the unit.
5. Close and latch cover.
UNCLOGGING BAGGER
WARNING: MOVING PARTS can cut or
amputate body parts.
NEVER attempt to clear boot assembly while
engine is running.
ALWAYS stop engine, remove key, and wait for
moving parts to stop.
Sharp edges can cut. Movement of parts can
cut off fingers or a hand. Wrap blade(s), wear
sturdy gloves and use extreme caution when
working near blades.
If hose or boot assembly become clogged, stop forward
motion and allow unit to clear itself. If unit will not clear
itself, unclog the hose and/or boot assembly manually as
instructed below.
Figure 20
1. Stop engine and remove ignition key. Wait for all
moving parts to stop.
2. Flip thumb latch and remove hose.
3. Remove grass from hose and boot assembly.
4. Install hose and secure with thumb latch.
OPERATING TIPS
IMPORTANT: DO NOT remove more than 1 1/4" (3.2 cm)
of grass when bagging.
• Cut grass when it is dry.
• Cut grass in two passes when cutting thick, long, or
wet grass. Make the first cut higher than desired.
Make the second cut at desired height.
• Always use full throttle when bagging.
• Adjust ground speed as needed to allow the bagger
to pick up debris.

MAINTENANCE

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Ariens/Gravely Dealers will provide any service or
adjustments which may be required to keep your unit
operating at peak efficiency.
Interval Task
Check
counter
weight
Check
Hose
Check
mesh
bags
Each
Check
Use
Fasteners
Inspect
Bagger
Parts
Clean Unit Clear away debris in boot
15
Action
Ensure the cast iron weight
is installed and securely
fastened.
Ensure hose is securely
fastened to cover assembly and
boot assembly.
Ensure mesh bags are installed,
and bagger cover is closed and
securely latched.
Ensure all hardware is tight. Pay
special attention to the guards
and safety shields.
Inspect bagger parts for holes,
abrasions, or structural damage.
Replace any worn or damaged
parts with Ariens/Gravely service
parts.
assembly, in tube, and in cover
assembly.