Advertisement
Installing the Smart Stack Coaster
GENERAL INFORMATION
The Smart Stack Pagers are used in conjunction with the Pagertec transmitters. The
guest pagers are used as an on-premise paging system to increase efficiency by alerting
customers who are waiting, usually for services or goods.
CHARGING BASE INSTALLATION
1. Install the charging base per the directions received with the charger kits.
2. Charge pagers for 24 hours prior to first use. Note: Keep rechargeable pagers on
charge even during extremely long periods of inactivity.
WARNING: Do not stack more than 15 guest pagers on a single charging base. Do not
connect more than 3 charger base plates to a single power supply. Only use the power
supply that came with your charger. Damage caused from improper electrical connection
including but not limited to the incorrect power supply is not covered under the standard
warranty. If you're uncertain about which power supply to use, contact our customer
support department.
OPERATION
1. When a guest arrives, remove a pager from the charging stack. Pagers will light up for 3
seconds.
2. Record the pager number and hand to your guest.
3. Page the pager by entering the number into the transmitter.
4. Pagertec Smart Stack Coaster Pagers will flash or vibrate (if enabled) depending on the
page mode sent by the transmitter.
Note: Beep modes will still flash and vibrate (if enabled) with no audible beep.
5. Transmitters can also send predefined time limits for each of the pager alert modes.
5
Advertisement
