Table of Contents
Advertisement
I nstalling the Matrix Plus Paging System
GENERAL INFORMATION
Matrix Plus Pagers are used in conjunction with the Pagertec transmitters. The pagers
are used as an on-premise paging system to increase efficiency by alerting customers or
staff members.
CHARGING BASE INSTALLATION
1.
I nstall the charging base.
2.
C harge pagers for 24 hours prior to first use.
WARNING
: Do not connect more than 2 charger base stations to a single power supply.
Only use the power supply that came with your charger. Damage caused from improper
electrical connection including but not limited to the incorrect power supply is not
covered under the standard warranty. If you're uncertain about which power supply to
use, contact our customer support department.
OPERATION
1.
R emove a pager from the charging station. Pagers will light up for 3 seconds.
2.
R ecord the pager number.
3.
E nter the number of the message you wish to send (#00 - 99)
4.
T hen, select the pager you wish to activate by entering the (pager number) into the
transmitter and then pressing "SEND"
5.
P agers will Vibrate, Flash, and or Beep depending on the alertmode.
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Matrix Plus and is the answer not in the manual?
Questions and answers