Advertisement
SET ALERT TIME
Note: Put all the pagers on the charger and disconnect the power supply going to the
charger. Connect the charger back to the wall outlet. You will have three (3) minutes to
program the Set Alert Time.
With this feature, you can set the alert time how long the pager alerts when the pager receive
the signal from the transmitter.
To change the Alert time mode of your pagers, follow these instructions:
1.
At the "Set Alert Time" menu press
2.
Use the
"▲""▼"
3.
Select one of 9 Alert times as below then press
1.
2 SEC
2.
5 SEC
3.
10 SEC
4.
15 SEC
5.
30 SEC
6.
60 SEC
7.
90 SEC
8.
120 SEC
9.
Continuance
• The pagers will now respond with your new selected alert time mode.
• Return all the pagers to the charger base or plug the power supply. The pagers are
ready to receive the page with its new alert mode.
• At this point, all of the pagers in your system should alert for the amount of time that
you selected.
4.
Press
"C"
key to exit, and return to the main menu.
"Enter"
key to scroll through the different times
"SEND"
8
Advertisement
