Advertisement
Smart Stack Coaster with BMTX-1000 Guide
GENERAL INFORMATION
The Smart Stack Pagers are used in conjunction with the Pagertec transmitters. The guest pagers
are used as an on-premise paging system to increase efficiency by alerting customers who are
waiting, usually for services or goods.
CHARGING BASE INSTALLATION
1.
Install the charging base per the directions received with the charger kits.
2.
Charge pagers for 24 hours prior to first use.
Note:
K eep rechargeable pagers on charge even during extremely long periods of inactivity.
W ARNING:
D o not stack more than 15 guest pagers on a single charging base. Do not
connect more than 3 charger base plates to a single power supply. Only use the power supply
that came with your charger. Damage caused from improper electrical connection including but
not limited to the incorrect power supply is not covered under the standard warranty. If you're
uncertain about which power supply to use, contact our customer support department.
OPERATION
1.
When a guest arrives, remove a pager from the charging stack. Pagers will light up a
couple seconds.
2. Record the pager number and hand it to your guest.
3. Page the pager by entering the number into the transmitter.
4.
Pagertec Smart Stack Coaster Pagers will flash or vibrate (if enabled) depending on
the page mode sent by the transmitter.
Advertisement
