Advertisement
Quick Links
Advertisement
Related Manuals for pagertec SMART STACK PAGING SYSTEM
Summary of Contents for pagertec SMART STACK PAGING SYSTEM
- Page 1 Smart Stack Paging System...
- Page 2 Thank you for choosing Pagertec Thank you for choosing Pagertec as your provider for your wireless paging requirements. We greatly appreciate your confidence in our products. At Pagertec our greatest commitment is providing you with total customer satisfaction. Please take a few minutes to review this manual prior to installing and operating your system.
-
Page 3: Paging System
Smart Stack PAGING SYSTEM... - Page 4 Installing the Transmitter The first consideration in the placement of the transmitter is convenience. It should be readily accessible in a central location within the paging area. Pay close attention to nearby obstructions such as walls, pipes, ducts, mirrored glass, or other similar barriers that may weaken or misdirect transmitted signals.
-
Page 5: Operation
2. Record the pager number and hand to your guest. 3. Page the pager by entering the number into the transmitter. 4. Pagertec Smart Stack Coaster Pagers will flash or vibrate (if enabled) depending on the page mode sent by the transmitter. -
Page 6: System Programming
Pagertec pagers are made from industrial-strength, polycarbonate material. However, this material is susceptible to hairline cracking if non-approved cleaners are used. When cleaning Pagertec pagers, you should only use ETHYL ALCOHOL (ethanol) or ISOPROPYL ALCOHOL-BASED CLEANERS. We have done extensive testing with available cleaning materials and have not found any issues with either ethyl alcohol (ethanol) or isopropyl alcohol (IPA). - Page 7 SET ALERT MODE Note: Put all the pagers on the charger and disconnect the power supply going to the charger. Connect the charger back to the wall outlet. You will have three (3) minutes to program the Set Alert Mode. With this feature you can have the option of changing your pagers alert type.
- Page 8 SET ALERT TIME Note: Put all the pagers on the charger and disconnect the power supply going to the charger. Connect the charger back to the wall outlet. You will have three (3) minutes to program the Set Alert Time. With this feature, you can set the alert time how long the pager alerts when the pager receive the signal from the transmitter.
- Page 9 SET PAGER OFF With this feature you can have the option of turning off the pager to save battery. 1. Remove all the pagers from the chargers 2. At the “set pager off” press “ENTER” 3. Pager off ? will appear on display 4.
- Page 10 30 seconds. Walk around your property. When you reach the point where the coasters do not flash consistently, this is your maximum range. If you would like to increase your power level, exit range test and call Pagertec. • Press the “CANCEL”...
-
Page 11: Fcc Compliance And Advisory Statement
FCC COMPLIANCE AND ADVISORY STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.