Technical Specifications - Beurer BM 47 Instructions For Use Manual

The technical alarm is a non-locking alarm and must not be
reset. The signal shown on the display will disappear auto-
matically after about 8 seconds.
9. Cleaning and storing the unit
• Clean your blood pressure device carefully with a slightly
damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under
water, as this can cause liquid to enter and damage the
unit.
• If you store the unit, no heavy objects should be placed
on top of it. Remove the batteries. The cuff line should not
be bent sharply.

10. Technical specifications

Model no. BM 47
Measurement Oscillometric, non-invasive blood
method pressure measurement on the upper
arm
Measurement range Cuff pressure 0-300 mmHg,
systolic 60-260 mmHg,
diastolic 40-199 mmHg,
Pulse 40-180 beats/minute
Display accuracy
Measurement inac-
curacy
Memory
Dimensions
Weight
Cuff size
Permissible operating
conditions
Permissible storage
conditions
Power supply
Battery life
Accessories
25
Systolic ± 3 mmHg,
diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Max. permissible standard deviation
according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
4 x 30 memory spaces
L 134 mm x W 102 mm x H 52,5 mm
Approximately 280g (without batter-
ies and cuff)
22 to 35 cm
+10 °C to +40 °C, ≤ 85 % relative air
humidity (non-condensing)
-20 °C to +50 °C, ≤ 85 % relative air
humidity, 800-1050 hPa ambient
pressure
AA batteries
4 x 1,5 V
For approx. 500 measurements,
depending on the blood pressure
level and/or pump pressure
Instruction for use, 4 x 1.5 V AA bat-
teries, storage pouch