Program Key - Compuprint 9058D User Manual

Configuring the Printer
ON LINE Key
ON LINE
Normal Function
Program Function Pressing this key, the input buffer is

PROGRAM Key

PROGRAM
Normal Function
PITCH
Shift Function
Program Function Exits the current printer setup. See also
18
•
Enables or disables the printer.
•
If this key is pressed while powering
the printer on, the self test is printed;
the printout is topped pressing this
key again.
•
In an error condition, once the error
cause has been removed, press this
key to enable the printer.
•
If the Tear-Off Function in the
Program Setup is set to Manual, press
this key to position the paper for the
Tear-Off.
cleared an a break (250 msec.) on a serial
interface is sent. The message RESET &
BREAK is displayed.
Enables the printer setups as follows:
•
Pressing this key while powering on
the printer,
Configuration is selected.
•
Pressing this key when the printer is
enabled without printing or disabled,
( indicator unlit) the Program
READY
Setup is enabled.
Selects the pitch to be used with the
currently selected font. The selected pitch
is valid until the printer is turned off.
"How to leave the Configuration Setup",
later in this section.
the Power-On
A78408098-005