Chapter 5
Create a Logix Designer Project
Before You Begin
Before you begin, complete these tasks:
•
The tasks described in Chapter 1,
Hardware on page
–
Install the EtherNet/IP network
–
Install the controller and the local expansion module
–
Wire power to the controller
•
The tasks described in Chapter 2,
page
33, including:
–
Install the Studio 5000 environment and RSLinx Classic software
Logix Designer application is installed when you install the Studio 5000 environment.
–
Configure an EtherNet/IP driver in RSLinx Classic software
–
Set the IP address for the computer
–
Load firmware on the controller
•
Set the IP address for the controller as described in Chapter 3 on
•
Verify that all devices are powered.
What You Need
You need the Logix Designer application to complete the tasks in this chapter.
64
Prepare the CompactLogix 5370 L3 Controller
17, including:
Prepare the Computer and Load Controller Firmware on
Rockwell Automation Publication IASIMP-QS023B-EN-P - December 2012
page
51.