Before You Begin; Chapter 3 Configure The Ethernet/Ip Network Before You Begin - Allen-Bradley 1769-L30ERM Quick Start Manual

Chapter 3 Configure the EtherNet/IP Network

Before You Begin

Before you begin, complete these tasks.
• The tasks described in Chapter 1,
Hardware on page
–
Install the EtherNet/IP network
– Install the controller and the local expansion module 1769-OB16 output module
–
Wire power to the controller
–
Make network connections
IMPORTANT
•
The tasks described inChapter 2,
page 33, including:
–
Install the Studio 5000 environment and RSLinx Classic software
Logix Designer application is installed when you install the Studio 5000 environment.
–
Configure an EtherNet/IP driver in RSLinx Classic software
– Set the IP address for the computer
–
Load firmware on the controller
•
Verify that power is applied to all devices
50
Prepare the CompactLogix 5370 L3 Controller
17, including:
If you connect all of the devices, including the computer, through an Ethernet switch, you can create an
isolated network. This chapter assumes you are using an isolated network. If you are not, contact your
network administrator to obtain IP addresses.
Prepare the Computer and Load Controller Firmware
Rockwell Automation Publication IASIMP-QS023B-EN-P - December 2012
on