Octal Label Kit Installation; Apply The Octal Filter Label; Apply The Octal Door Label - Allen-Bradley SLC 500 User Manual

Octal Label Kit Installation

1. Install a tie wire to secure your wiring and keep it neat. (If you
feed the tie into one hole, it is routed back out through the
other.)
2. Cover any unused slots with card slot fillers (catalog number
1746-N2) to keep the chassis free from debris and dust.
The octal label kit consists of an octal filter label and a door label. Use
these octal labels to replace the decimal labels that are attached to the
I/O modules. The kits can be obtained through your Allen-Bradley
distributor. (The octal label kit is applicable when using 1746 I/O with
PLC-5 processors via a 1747-ASB Remote I/O Adapter.)

Apply the Octal Filter Label

1. Remove the octal filter label from its paper carrier.
2. Align the octal filter label numbers horizontally to the module
color bar and over the decimal filter numbers, as shown in the
illustration below.
3. Apply the octal label to the filter.
4. Press firmly to ensure proper adhesion of the label.

Apply the Octal Door Label

1. Remove the octal door label from its paper carrier.
2. Align it over the decimal door label on the inside of the door.
3. Press firmly to ensure proper adhesion of the label.
Wiring Your I/O Modules
Publication 1747-UM011G-EN-P - June 2008
117