Remove The Memory Module; Install Your Power Supply - Allen-Bradley SLC 500 User Manual

Installing Your Hardware Components
104
Processor Type 1747-M1, -M2, -M3
1747-L514, 1747-L524
No Jumper J1
1747-L511, 1747-L531,
1747-L532, 1747-l533,
1747-L541, 1747-L542,
1747-L543, 1747-L551,
1747-L552, 1747-L553

Install Your Power Supply

Publication 1747-UM011G-EN-P - June 2008
3. Place jumper J1 as shown below.
1747-M4
No Jumper J1
4. Install the processor module into the chassis.
5. Restore power to the controller.

Remove the Memory Module

Follow this procedure to remove the memory module.
1. Remove power and pull out the processor.
2. Grasp the carrier tabs (or connector for the SLC 5/03, SLC 5/04,
and SLC 5/05 processor) with your thumb and index fingers,
then gently but firmly lift upwards on either end of the memory
module carrier.
3. When the end is partially raised, begin lifting the other end in
the same manner. Repeat this until the memory module has
been completely removed from the socket.
If you have multiple chassis configurations, install the chassis
interconnect cable before installing the power supply.
See Install Your Chassis Interconnect Cable on page 108.
Also, the power supply terminals accept two 2 mm
and are marked as shown in the figure on page 106.
Invalid Settings
No Jumper J1
2
(#14 AWG) wires