Octal Label Kit Installation; Applying The Octal Filter Label; Applying The Octal Door Label - Allen-Bradley SLC 500 User Manual

Octal Label Kit Installation

Allen-Bradley PLCs
2. Cover any unused slots with card slot fillers (Catalog Number
1746-N2) to keep the chassis free from debris and dust.
The octal label kit consists of an octal filter label and a door label. Use
these octal labels to replace the decimal labels that are attached to the
I/O modules. An octal label kit is included with the I/O modules listed
in the table on the following page. The kits can also be obtained
through your Allen-Bradley distributor. (The octal label kit is
applicable when using 1746 I/O with Allen-Bradley PLC-5 processors
via a 1747-ASB Remote I/O Adapter.)

Applying the Octal Filter Label

1. Remove the octal filter label from its paper carrier.
2. Align the octal filter label numbers horizontally to the module
color bar and over the decimal filter numbers, as shown in the
illustration below.
3. Apply the octal label to the filter.
4. Press firmly to ensure proper adhesion of the label.

Applying the Octal Door Label

1. Remove the octal door label from its paper carrier.
2. Align it over the decimal door label on the inside of the door.
3. Press firmly to ensure proper adhesion of the label.
Wiring Your I/O Modules
Publication 1747-UM011C-EN-P - December 2001
7-7