Table of Contents
Advertisement
Open the Access Door
Open the enclosure door to access the power switch, controller USB port, memory card, and key.
1. Loosen the four (captive) screws on the front of the enclosure.
2. Gently lift the door and rotate it counter-clockwise from the pivot at the lower left corner.
The door remains attached to the enclosure.
3. Close the access door on the enclosure and torque the four screws to 3.8 N•m (33.5 lb•in).
IMPORTANT
When the access door is open, the Armor ControlLogix controller rating is Type 1.
Remove and Install the Memory Card
If you want to remove the memory card, follow these steps.
IMPORTANT
Verify that the memory-card status indicator is off and that the card is not in use before removing it.
1. Open the enclosure door to access the controller.
2. Turn the keyswitch to the PROG position.
3. Press and release the memory card to eject it.
4. Remove the memory card.
5. Turn the keyswitch to the REM position.
6. Close the enclosure access door.
Follow these steps to install the memory card.
ATTENTION: If you are not sure of the contents of the memory card, before you install the card, turn the keyswitch of the controller to the PROG position.
Depending on the contents of the card, a power cycle or fault could cause the card to load a different project or operating system into the controller.
1. Open the access door on the enclosure.
2. Verify that the memory card is locked or unlocked according to your preference.
Unlocked
3. Insert the memory card into the memory card slot.
4. Gently press the card until it clicks into place.
5. Close the enclosure access door.
Locked
Rockwell Automation Publication 1756-IN061B-EN-P - February 2017
Armor ControlLogix Controllers
Pivot Point
7
Advertisement
Table of Contents
