Adjusting The Audio - ViewSonic Office Theater PJ820 User Manual

Adjusting the audio

The audio can be adjusted using buttons on the projector and buttons on the remote control. Also, you can use
the Remote Control Unit to make additional audio adjustments.
Remote
Control Unit
Remote
Control Unit
ViewSonic PJ820
Adjusting the volume with the Remote Control Unit
The volume can be adjusted by pressing the VOL (+/-) buttons on
the Remote Control Unit.
+ increases volume
- decreases volume
NOTE: If these buttons are pressed while another function is
currently displayed on the screen, the volume will still be adjusted
but the current volume setting and the volume bar display will not
appear. The volume can also be adjusted from an on-screen display
menu. The volume output level remains on the screen for
approximately three seconds.
Muting the sound with the Remote Control Unit
If the MUTE button on the Remote Control Unit is pressed, MUTE
will be displayed on the screen shown on the left and the sound will
be muted. If the MUTE button is pressed again, the on-screen
display will be cleared and the normal sound volume will be
restored. The volume output level will remain displayed on the
screen for approximately three seconds.
NOTE: If the MUTE button is pressed while the on-screen display
for another function is currently on the screen, the volume will still
be muted but the MUTE on-screen display will not appear.
If the power supply is turned off or either of the VOL (+/-) buttons is
pressed, the mute setting will be canceled.
You can also mute the picture together with the sound by pressing
the MUTE button. For details of this process see the following page.
When the picture has been turned off in this way, PICTURE MUTE
will be displayed on the screen.
To adjust the volume using the on-screen display
1 Press the MENU button on the projector or the remote control to
display the MENU screen.
2 Press the /\ or \/ button to select AUDIO.
3 Press the < or > button to display the AUDIO screen. If the
STD (Standard) button is pressed while the AUDIO screen
shown on the left is displayed, STD turns yellow in the top-right
corner of the screen, and only the BALANCE setting resets to
the factory setting showing the value and bar displays in yellow.
4 Press the /\ or \/ button to select VOLUME.
To adjust the balance, select BALANCE instead.
Continued
Operation
31