Safety Guidelines - ViewSonic Office Theater PJ820 User Manual

Super bright svga lcd projector
Table of Contents

Advertisement

Caution: Use a power cable that is properly grounded. Always use the AC cords listed
below for each area:
In other areas, use AC cord which meets local safety standards.
This appliance is supplied with a moulded three pin mains plug for your safety and
convenience. A 13 amp fuse is fitted in this plug. Should the fuse need to be replaced,
ensure that the replacement fuse has a rating of 13 amps and that it is approved by
ASTA or BSI to BS1362. Check for the ASTA mark
of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the
fuse is replaced. If you lose the fuse cover, the plug must not be used until a
replacement cover is obtained. A replacement fuse cover can be purchased from your
local ViewSonic dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN
YOUR HOME, THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF
AND DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL
SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted, please observe the wiring code as shown below. If in any
doubt, please consult a qualified electrician.
WARNING: THIS APPLIANCE MUST BE GROUNDED.
Important:
The colors of the wires in the main leads of this appliance may not correspond with the colored
markings identifying the terminals in your plug. Please comply with the following instructions:
Note:
ViewSonic PJ820

Safety Guidelines

USA . . . . . . . . . . . . . . . . . . . . . . . . UL
Canada . . . . . . . . . . . . . . . . . . . . . CSA
Germany . . . . . . . . . . . . . . . . . . . . VDE
Switzerland . . . . . . . . . . . . . . . . . . SEV
Britain . . . . . . . . . . . . . . . . . . . . . . . BASEC/BS
Japan . . . . . . . . . . . . . . . . . . . . . . . Electric Appliance Control Act
FOR EUROPEAN VERSION ONLY
The wires in the main leads are coloured in accordance with the following code:
Green-Yellow . . . . . . . . . . . . . . . . . . . . . Ground
Blue . . . . . . . . . . . . . . . . . . . . . . . . . . . . Neutral
Brown . . . . . . . . . . . . . . . . . . . . . . . . . . Live
l
The Green-Yellow wire must be connected to the Green or Green-Yellow terminals in
the plug marked with the letter E or with the ground symbol.
l
The Blue wire must be connected to the Black
terminal in the plug marked with the letter N.
l
The Brown wire must be connected to the Red
terminal in the plug marked with the letter L.
To replace the fuse, open the fuse
compartment with a screwdriver.
or the BSI mark
on the body
iii

Advertisement

Table of Contents
loading

Table of Contents