Replacing D3940 I/O Adapter - HPE Synergy 12Gb SAS Storage User Manual

The drawer power LED will not illuminate green until a compute module containing one or more logical
JBODs that are assigned to the D3940 Storage Module is powered on.
Verifying proper operation
Check the following to verify that the module is working properly:
•
LEDs—See "Front panel and LED definitions (on page 6, on page 7)" and check for healthy LED
patterns.
•
OneView—View system information, status alerts, device information, and confirm that the device
status is Normal. For more information, see the OneView user guide, available on the Hewlett
Packard Enterprise website (http://www.hpe.com/info/synergy-docs).

Replacing D3940 I/O adapter

Removing the failed D3940 I/O adapter
Open the release lever.
1.
Remove the failed module from the frame interconnect bay.
2.
Installing the replacement D3940 I/O adapter
To install the replacement I/O adapter, see "Installing I/O adapter (on page 20)."
Verifying proper operation
Check the following to verify that the module is working properly:
•
LEDs—See "Front panel and LED definitions (on page 6, on page 7)" and check for healthy LED
patterns.
•
OneView—View system information, status alerts, device information, and confirm that the device
status is Normal. For more information, see the OneView user guide, available on the Hewlett
Packard Enterprise website (http://www.hpe.com/info/synergy-docs).
Operations 48