Advanced Setup Tab - MTS Systems Level Plus Operation And Installation Manual

Model MR Operation and Installation Manual
Setup

ADVANCED SETUP TAB

Gradient : A calibration factor that is specific to each level transmitter. This value should not be changed unless directed to do so by Technical
Support.
Length: The order length of the transmitter. This value should not be changed unless directed to do so by Technical Support.
Units: The unit of measure for Length and Head Adder. This is used when writing new values of Length and Head Adder to the transmitter.
Use the Output Tab to change units of measure for all data.
Head Adder: The distance between the sensing element and the order length. Each model has a slightly different head adder. This value
should not be changed unless directed to do so by Technical Support.
Transmitter style
NEMA 4X housing, standard rigid pipe
Single or Dual Cavity Housing, standard rigid pipe
NEMA 4X housing, flexible hose
Single or Dual Cavity Housing, flexible hose
Display Units: Units used only on LCD display of units, mA, or percent Float #2: The second or interface float that can be enabled or disabled
Temperature: The ability to measure temperature that can be enabled or disabled
Display: The optional LCD display that can be enabled or disabled
Alarm: The output state that the level transmitter enters upon failure. Alarm can be Low (3.8 mA) or High (21.5 mA).
Level Plus ® Liquid-Level Transmitters - M-Series Model MR Analog Transmitter
Operation and Installation Manual, Part No.: 550720 Revision K (EN) 02/2016
Length
4.3 to 4.5 in (109 to 114 mm)
5.6 to 5.7 in (142 to 145 mm)
14.0 to 14.5 in (356 to 368 mm)
14.0 to 14.5 in (356 to 368 mm)
24
MTS Sensors