Mutec MC-3+ Smart Clock USB Operating Manual page 14

Control Elements and Terminals
9 »S/P-DIF & AESid IN«
This input receives either an unbalanced electrical digital audio or blank-frame signal in compliance with AES3id-2001 (revision
of 1995) or AES11-2003 (revision of 1997), or an unbalanced electrical digital audio or blank-frame signal in compliance with
the IEC 60958 standard. The input impedance is 75 Ω (BNC connector, female).
If you have for input of S/P-DIF signals only a cable with RCA, respectively Cinch connectors available, then use the RCA to BNC
adpater included in delivery.
10 »WCLK & 1–10M IN«
This input can receive a Word Clock, a Word Clock × 256 as well as a 1–10.0 MHz reference clock signal. The impedance of the
connector is 75 Ω (BNC connector, female).
11 »MAINS IN«, Power Switch + Mains connector (IEC)
This is the main switch for switching the device on and off. Connect the supplied IEC power cable to the device's mains con-
nector. Make sure that the power switch is turned off before connecting the device to your power source finally. Line voltages
within the range of 90...260 V with a frequency of 50 or 60 Hz can be applied. The internal power supply will automatically
make all necessary adjustments.
Read the Safety Instructions at the beginning of this manual!
Attention
For detailed specifications of all interfaces, please refer to the »Pin Assignment of the Connectors« and »Technical Data«
sections in the Appendix chapter.
14