Rear Panel - Mutec MC-3+ Smart Clock USB Operating Manual

Control Elements and Terminals

Rear Panel

3
2 4
1
1 »WCLK OUT 1 – 2«
These 2 pairs of Word Clock outputs transfer all standard Word Clock rates, Word Clock × 256 for older digidesign ProTools™
systems and × 512 clock rates for special High-End interfaces. Their numbering is aligned to the apropriate menus on the front
panel. The individual BNC connectors are pairwise marked as »A« and »B«, which allows for, e.g. simple documentation of the
connected devices. The impedances of all connectors are 75 Ω (BNC connectors, female).
2 »S/P-DIF OUT 3«
The S/P-DIF output transmits an unbalanced electrical S/P-DIF digital audio or blank frame signal in compliance with the IEC
60958 standard. The interface impedance is 75 Ω (BNC connectors, female).
3 »AES3/11id OUT 4«
The AES/EBUid output transmits an unbalanced electrical digital audio or blank-frame signal in compliance with AES3id-2001
(revision of 1995) or AES11-2003 (revision of 1997).
4 »S/P-DIF OUT 3«
These two S/P-DIF outputs, available as optical and coaxial interfaces, transmit an optical (»OP«) and unbalanced electrical
(»CO«) S/P-DIF digital audio or blank frame signal in compliance with the IEC 60958 standard. The coaxial interface impedance
is 75 Ω. (RCA connector), the optical interface offers a Toshiba Toslink
the apropriate menu on the front panel.
5 »AES3/11 OUT 4«
This AES/EBU output transmits a transformer-balanced electrical digital audio or blank-frame signal in compliance with AES3-
1997 (revision of 1992) or AES11-2003 (revision of 1997). Its numbering is aligned to the apropriate menu on the front panel.
The output impedance is 110 Ω (XLR connector, male).
6 »AES3/11 IN«
This AES/EBU input receives a balanced electrical digital audio or blank-frame signal in compliance with AES3-1997 (revision of
1992) or AES11-2003 (revision of 1997). The input impedance is 110 Ω (XLR connector, female).
7 »S/P-DIF IN (OP)«
This optical S/P-DIF input receives an optical S/P-DIF digital audio or blank frame signal in compliance with the IEC 60958
standard. The optical interface offers a Toshiba Toslink
8 »USB I/O«
This USB (Universal Serial Bus) interface receives or sends data streams in compliance with USB2.0. When connecting the
MC-3+USB to a MS Windows PC, please install the provided USB2.0 Audio Class Driver for Windows at first on your computer.
Refer to the »Installation of the USB2.0 Audio Class Driver for Windows« section on page 13 for further details (USB-B connec-
tor).
8
5 6 7
connector, EIAJ standard.
TM
10
9 11
connector, EIAJ standard. Its numbering is aligned to
TM
13