Control Elements And Terminals; Front Panel - Mutec MC-3+ Smart Clock USB Operating Manual

Hide thumbs Also See for MC-3+ Smart Clock USB:

Table of Contents

Control Elements and Terminals

Information

MUTEC offers optical cables of various lengths that have been specifically tested for the transmission of ADAT™ and S/P-DIF

signals. Ask your local dealer for such cables!

Control Elements and Terminals

1 »POWER«

This red LED lights up when the unit is switched on with the rear panel power switch.

2 »MENU«

Use this key to access the different menus.

3 »SELECT«

Use this key to select a function within a specific menu.

4 »MODE«

This menu allows to select the clock references for internal and external synchronization as well as the reference for external-

ly-referenced digital audio re-clocking. All three LED rows act in functional dependence.

5 »REFERENCE«

This menu allows to select the clock references for external synchronization and audio re-clocking.

6 »CLOCK

OUT

Here, the basis clock rate for the Word Clock-, the AES3/11- and the S/P-DIF outputs can be selected, while the MC-3+USB

is running in the »INTERN« mode, or is locked to an external 1–10.0 MHz reference, or when a DSD/DoP conversion to PCM

audio is carried out.

7 »CLOCK

MULTIPLIERS

This menu lets you determine the factor by which the basis clock rate is multiplied additionally. Settings can be made individu-

ally for every pair of Word Clock outputs (»1–2«) as well as for the AES3 (»4«) and S/P-DIF (»3«) outputs.

8 »STATUS«

This menu indicates various signal status of the incoming reference clock or digital audio signal.

9 »CLOCK

This menu indicates the clock rates of the incoming clock reference or digital audio signal. DSD/DoP signals received through

the USB interface can be identified with single ( × 64), double ( × 128) or quadruple ( × 256) clock rate.

Table of Contents

Show Quick Links

Table of Contents