Installing The Battery In Terminals Equipped With A Battery Door Lock - Honeywell dolphin 70e black User Manual

Dolphin 70e Black model terminals not equipped with a battery door lock are designed for use with
battery part numbers BAT-STANDARD-01 (Li-ion 3.7V, 6.179 watt hour) and BAT-EXTENDED-01
(Li-ion 3.7V, 12.358 watt hour) manufactured for Honeywell International Inc. See page
installation instructions.
Back panel of the terminal
with standard battery door
shown.

Installing the Battery in Terminals Equipped with a Battery Door Lock

The terminal is shipped with the battery packaged separate from the unit. Perform the steps illustrated
below to install the battery.
Note: If your Dolphin 70e Black model type does not have a battery door lock, refer to the battery installation
instructions on page 2-3.
Ensure all components are dry prior to placing the battery in the terminal. Mating wet components may cause
damage not covered by the warranty.
Battery Door Lock
1
5
Important - All battery and connector doors must be present, undamaged, and properly closed to
maintain the environmental rating of the terminal.
For information on how to remove the battery, see
2 - 2
2
Note: Standard battery and standard battery door shown.
6
Replacing the Battery
4
Apply pressure to the edges
of the battery door before
engaging the lock to ensure
the door is properly closed.
on page 2-15.
2-3 for battery
3