Bottom Panel; Power; Connecting Power To The Ebase - Honeywell dolphin 70e black User Manual

DC Power Jack
See Power.

Bottom Panel

For details on how to mount the eBase, see
Compliance Label

Power

The base requires 12 Volts DC input for communications, battery charging, and power output to the ter-
minal; the power adapter included with the base converts the voltage from the AC power source to
12 Volts DC. Use only a UL listed power supply, which has been qualified by Honeywell with out-
put rated at 12VDC and 3 amps with the device. The operating temperature range is -10° to 50°C (14°
to 122°F). Honeywell recommends that you leave the eBase connected to its power source at all times,
so that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.

Connecting Power to the eBase

1. Plug the A/C power cord into the power
adapter.
2. Plug the power cable into the power connector
on the back of the eBase.
3. Plug the A/C power cord into a grounded power
source.
Mounting the eBase on page
Power Adapter
A/C Power Cord
12-8.
Serial Number Label
MAC Address Label
Power Cable
12 - 5