Leveling The Appliance; Connecting Supply Hose - LG fh695bdh6n Owner's Manual

Leveling the Appliance

If the floor is uneven, turn the adjustable feet as
required (Do not insert pieces of wood etc. under
the feet). Make sure that all four feet are stable and
resting on the floor and then check that the appliance
is perfectly level (Use a spirit level).
• Once the appliance is level, tighten the lock nuts
up towards the base of the appliance. All lock nuts
must be tightened.
Raise
Lock nut
Diagonal Check
• When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions). If the appliance
rocks when pushing the machine top plate
diagonally, adjust the feet again.
NOTE
• Timber or suspended type flooring may contribute
to excessive vibration and unbalance.
• If the washing machine is installed on a raised
platform, it must be securely fastened in order to
eliminate the risk of falling off.
Lower
Tighten all 4
lock nuts securely

Connecting Supply Hose

• Water supply pressure must be between 0.1 MPa
and 1.0 MPa (1.0‒10.0 kgf/cm
• Do not strip or crossthread when connecting inlet
hose to the valve.
• If the water supply pressure is more than 1.0 MPa,
a decompression device should be installed.
• Periodically check the condition of the hose and
replace the hose if necessary.
Checking the Rubber Seal on the
Supply Hose
Two rubber seals are supplied with the water inlet
hoses. They are used for preventing water leaks.
Make sure the connection to taps is sufficiently tight.
Hose connector
Rubber seal
Hose connector
).
2
Rubber seal
EN
13