Install Pcmcia Cards; Install The 2.4Ghz Type Ii Pcmcia Radio; Figure 2-29 Inserting The 2.4Ghz Type Ii Pcmcia Radio - LXE VX6 Reference Manual

PCMCIA, CF and SD Slots

Install PCMCIA Cards

Equipment Needed: Phillips No. 1 screwdriver and a Torque wrench capable of measuring to 9±1
inch pounds (1.016±.11 N/m).
Note: The example below details installing a 2.4GHz radio card.
PCMCIA cards is similar, except there is no antenna.

Install the 2.4GHz Type II PCMCIA Radio

Caution
!
1. Turn the VX6 off and detach the power cable.
2. Loosen the three (3) Phillips head screws securing the access panel cover so the cover can
be removed. The screws are a captive part of the cover and cannot be removed.
Partially insert the 2.4GHz Type II PCMCIA Radio into Slot A (the upper right slot).
Caution
Note:
E-EQ-VX6RG-A
The LXE Model VX6 Vehicle Mount Computer is specifically for use with LXE
Model 6726 and 6816 2.4GHz Type II PCMCIA radios. Substitution of other
PCMCIA radios will void the FCC, Industry Canada and other international
radio certifications for the Model VX6 Vehicle Mount Computer and is strictly
prohibited.
Slot A MUST BE used for the radio card. Installing a radio card in Slot B can
result in pinching or other damage to the internal antenna cable.
!
SD
Radio Card

Figure 2-29 Inserting the 2.4GHz Type II PCMCIA Radio

The tethered access panel cover is not shown in the illustration above.
CF ATA PCMCIA A
PCMCIA B
41
Installation of other
VX6 Reference Guide