ZyXEL Communications NAP102 User Manual page 9

The following table describes the LEDs.
Table 1 NAP303 LEDs
LED COLOR
PWR/SYS Red
Green
Red
Green
Red
Green
Red
Green
Red
Green
Red
Green
Management Green
Amber
WLAN Green
WLAN Green
UPLINK Amber/
Green
LAN Amber/
Green
Locator White
Chapter 1 Introduction
STATUS DESCRIPTION
Slow Blinking (On for 1s, The NAP is booting up.
Off for 1s)
On
Off The NAP is ready for use.
On
On There is system error and the NAP cannot boot up, or the
NAP suffered a system failure.
Off
Fast Blinking (on for The NAP is undergoing firmware upgrade.
50ms, Off for 50ms)
Off
Slow Blinking (blink for 3 The Uplink port is disconnected.
times, Off for 3s)
Off
Slow Blinking (blink for 2 The wireless module of the NAP is disabled or failed.
times, Off for 3s)
Off
On The NAP is managed by the NCC.
Slow Blinking (On for 1s, The NAP is connected to the NCC, but not registered.
Off for 1s)
Slow Blinking (blink for 3 The NAP is searching for (discovering) the NCC.
times, Off for 3s)
On The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
On The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NAP is sending/receiving data through the port.
Off The port is not connected.
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the port.
Off The LAN port is not connected.
Blinking The Locator is activated and will show the actual location
of the NAP between several devices in the network.
Off The Locator function is off.
NAP Series User's Guide
9