Table of Contents
Advertisement
If ON is selected, do the following:
a.
Press the joystick to enter the POSITION adjustment screen, and then
adjust the position of the motion detection area by moving the joystick up or
down, left or right.
b.
Press the joystick to enter the SIZE adjustment screen, and then adjust the
size of the motion detection area by moving the joystick up or down, left or
right.
c.
If you are satisfied with position and size of the motion detection area, select
RET to save your settings and return to the MOTION menu. If you want to
change your settings, select AGAIN to return to the POSITION adjustment
screen.
4.
Set VALUE to define the sensitivity of the motion detection in the selected motion
detection area. Select a value between 0 and 100. The higher the value, the greater
the sensitivity. The default setting is 80.
5.
Set MOTION VIEW to OFF (default) or ON. When ON is selected, motion detected
in the selected motion detection area is highlighted.
6.
If you want, configure additional motion detection areas by repeating steps 2 to 5.
7.
Select RETURN to save your settings and return to the SPECIAL menu.
Privacy Mask
You can set up the camera to mask areas that you do not want displayed on the screen.
You can configure up to 8 privacy masks.
In the SPECIAL menu, navigate to PRIVACY, and set it to OFF (default) or ON.
If ON is selected, do the following:
1.
Press the joystick to enter the PRIVACY menu (see
Figure 16
2.
Select the privacy mask AREA you want to configure (1, 2, 3, 4, 5, 6, 7, or 8).
3.
Set AREA DISPLAY to ON (default) or OFF to show or hide the selected area.
Privacy Menu
Configuring the Camera | 19
Figure
16).
800-15429 - A - 07/2013
Advertisement
Table of Contents
