Operating Procedure - Jacobsen AR3 Safety, Operation And Maintenance Manual

7.3

OPERATING PROCEDURE

1. Under no circumstances should the engine be started without the operator seated on the tractor.
2. Do not operate tractor or attachments with loose, damaged or missing components. Whenever possible
mow when grass is dry
3. First mow in a test area to become thoroughly familiar with the operation of the tractor and control levers.
4. Study the area to determine the best and safest operating procedure. Consider the height of the grass,
type of terrain, and condition of the surface. Each condition will require certain adjustments or
precautions.
5. Never direct discharge of material toward bystanders, nor allow anyone near the machine while in
operation. The owner/operator is responsible for injuries inflicted to bystanders and/or damage to their
property.
6. Use discretion when mowing near gravel areas (roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious injuries to bystanders and/or damage the
equipment.
7. Disengage the drive motors and raise the implements when crossing paths or roads. Look out for traffic.
8. Stop and inspect the equipment for damage immediately after striking an obstruction or if the machine
begins to vibrate abnormally. Have the equipment repaired before resuming operation.
CAUTION
To help prevent injury, always wear safety
glasses, leather work shoes or boots, a hard
hat and ear protection.
CAUTION
Pick up all debris you can find before mowing.
Enter a new area cautiously Always operate at
speeds that allow you to have complete control
of the tractor
WARNING
Before you clean, adjust, or repair this
equipment, always disengage all drives,
lower implements to the ground, engage
parking brake, stop engine and remove key
from ignition switch to prevent injuries.
OPERATION 7
en-33