Table of Contents
Advertisement
Advanced Timer Recording
Tips
•
You can enter up to 32 programmes a month in advance.
(Each daily, weekly or series timer recording is counted as one
programme.)
To exit the timer recording list
Press [PROG/CHECK].
Notes
•
Recording may fail if there are changes to the station's programming.
•
" z " disappears from the unit's display when no timer programme is
set or when all timer programmes are deactivated.
•
"-------" is displayed on a series recording item if there will be no
episode of the series for the next 8 days. We recommend you
delete the "-------" item after you confirm the last episode of the
series is recorded.
•
The "Guide Link" function may not work if you manually change the
start/end time by over 10 minutes.
•
The "Guide Link" function may not work if you manually change the
start time later or the stop time earlier than the original time.
•
Programmes that failed to record are deleted from the timer
recording list at 4 a.m. two days later.
To deactivate timer programme
(e.g. to interrupt a daily or weekly timer
programming)
After performing step
(Red)
–
" z " on the timer recording list turns gray.
–
Press the "Red" button again to activate timer
programme.
42
RQT9431
(➔ Previous page)
HDD
Notes on timer recording
•
Timer recording will not be performed if the clock is not set.
•
During recording, timer recording standby or EXT LINK
standby, this unit cannot play discs or titles that do not
match the "TV System" setting. It is recommended "TV
System" be set to match the discs or title before playing
them. But to prevent the failure of the timer recording,
change back the settings before the recording starts. (➔
101)
•
Timer recordings are activated regardless of whether the
unit is turned on/in standby.
•
Timer recordings begin when the set time is reached even
when playing.
•
Timer recordings do not begin while copying in normal
speed mode.
•
If the unit is turned on when timer recording begins, it
remains turned on after recording finishes. It does not
turn off automatically. You can turn the unit off during timer
recording.
•
When you programme successive timer recordings to start
immediately one after the other, the unit cannot record the
part at the beginning of the later programmes.
Programme
Programme
Recorded
•
The "Overlapped Timer Recording" screen may be displayed
immediately after you turn on this unit, if new overlapping
occurred. Refer to "Check, Change, Delete Programmes, or
Resolve Overlapping" (➔ 41).
Not recorded
Recorded
Advertisement
Table of Contents
