For Models Two/Mh & Three/Mh; Limited Warranty - Acoustat Two/M Owners Manual And Assemly Instruction

CLEANING
Speaker cloth may be cleaned with
with polyester knit fabrics. U s e a cleaner such as K2R for small concentrated spots.
REMOVAL INTERFACE F O R MODELS TWO/M & THREE/M
OF
WARNING ALWAYS U N P L U G
If the interface must be removed from the speaker, the following procedure i s necessary to discharge the
panels
1, U N P L U G the interface from the A C outlet and dlsconnect the speaker leads from the amplifier.
2. CAREFULLY, lay the speaker on the floor. DROPPING I T CAN RESULT IN DAMAGE!
3. Unbolt the interface.
Set the interface on the floor behind the speaker, k i n g careful not
4.
from the speaker
Remove the center RED pin plug. Hold the wlre an Inch behind the pin and G E N T L Y pull. DO N O T
5.
G R A B THE P L U G ! Touch the RED tlp to either the BLUE or the WHITE terminal on the circuit board
two
Loosen the thumbscrews and remove the hooks
6.
WARNING: High static voltages are present in the charged panel. Failure to follow these procedures
will result in an annoying, but harmless electrical shock.
REMOVAL OF HYBRID MODULE FOR MODELS TWO/MH & THREE/MH
WARNING ALWAYS U N P L U G THE LN E CORD BEFORE REMOVl N G THE H Y B R I D MODULE!
If the Hybrid Module must
discharge the panels
1, U N P L U G the Hybrid Module from the AC outlet and disconnectthe speaker leads from the amplifier.
2. CARERILLY, lay the speaker on the floor DROPPING CAN RESULT IN DAMAGE!
3.
Unbolt the Hybrid Module, both thetwoscrewson the top of the module, and the threescrewsonthe
bottom of the speaker frame.
4. Set the module on the floor behind the speaker, being careful not to unplug the three wire groups
from the speaker.
5.
Remove the plastic insulator cover from the Hybrid Module.
6. Remove the center RED pin plug. Hold the wire an inch behind the pln and G E N T L Y pull.
G R A B THE PLUG! Touch the RED t i pto either the BLUE or the W H I T E terminal on the circuit board
7. Loosen the thumbscrews and remove the hooks.
two
Replace the plastic insulator cover
8.
WARNING High static voltages are present in a charged panel. Failure to follow these procedures will
an
result in annoylng. but harmless shock.

LIMITED WARRANTY

Amustat Corporation warrants to the owner that the Amustat loudspeaker system excluding the
Dynamic Woofer. will perform as specified and that it will befreeofdefectsin materialsand workmanship
for a period of
FIVE YEARS
any commercial cleaning fluid,
THE L I N ECORD B E F O R E REMOVNG
be
removed from the speaker, the following procedure i s necessary to
from the date of origlnal manufacture.
or anycleaner designed to be used
THE I N T E R F A C E !
to
8
unplug the three wire groups
D O NOT