Acoustat Two/M Owners Manual And Assemly Instruction page 4

5. CAREFULLY turn the speaker over, so that the back side is facing up. Remove one
Interface units from its carton and set aside the hardware needed Place the lnterface unit on the
floor at the base of the speaker. with the opening of the unit facing the back of the speaker.
You will notice three groups of wires extending through the rubber grommet on the speaker's firewall
6.
plate (lower rear area). Vlsually identify the three wire groups as the RED G R O U P , with a pin plug on
the end; the BLUE GROUP. with a blue sleeved hook on the end; and the WHITE GROUP, with a plain
hook on the end.
7. (Refer to Figure 1). Insert the pin plug into the RED socket on the circuit board of the interface unit.
Attach the BLUE hook to the board on the right side, identified by the blue tape on the nylon spacer
below the thumbscrew.
between the thumbxrewand thewasher, and tighten securely. Repeat the same procedureforthe
at
W H I T E group, the white side of the circuit board
8. Push any excess wire into the rubber grommet on the back of the speaker's base.
9. C A R E F U L L Y , place the interface unit on the back of the speaker's base, aligning the six mounting
holes. Be careful not to pinch any wires when you set the interface
screws
the six provided in your hardware packet. attach the interface unit to the speaker's back.
10. Install the two casters included with the unit into the bottom rear corners of the unit.(Thecastershave
nuts prethreaded into the stem.) When assembled and standing. the system should be perpendic-
ular to the floor. This perpendiculariiy can be determlned by
speaker is standing on; and 2) the amount of caster stem thread showing. If the system is to
positioned on a hardwood or cement floor, the caster must be screwed in all the way(or almost all
the way) into the interface unit. If the system is to be installed on
need to be screwed in only partially. T h e actual setting can be adjusted when the speaker is
standing.
Depending on the particular room set-up, a slight degree of tilt back or tilt forward may be
NOTE
desired. Thi i s can be accomplished by caster positioning. and will not cause stability problems with
the speaker system.
11.When the correct caster adjustment has been obtained. securely tighten the nut on the casterstem
against the interface unit chassis.
WARNING: The caster WlLL N O T support the entire weight of the assembled speaker system. When
movlng the system, Do NOT tilt the speaker off its base and roll it like
system slide the base along the floor with the caster acting as an assist only.
and
the word "Blue". Loosen the thumbscrew three turns. Place the hook
0
PANEL CONNECTIONS
0
(SIMPLIFIED VIEW)
0
1
AT INTERFACE
two
2
of
on
the metal firewall plate Using
factors: 1) the type
a carpeted surface, the caster will
hand truck. T o move the
o
the MK-121
floor the
of
be