Acoustat Two/M Owners Manual And Assemly Instruction page 7

9. Now, C A R E F U L L V stand the speaker back to an upright position, and then, lean the system forward
until the topedgeof speakerrestsonceagainon thefloor. Select the two casters and two largeflat
washers from the hardware kit. Note that each caster has a nut on its threaded stem. Install the flat
washer over the caster's stem and screw the caster/washer assembly into the wood block on the
bottom of the woofer box
caster/washer assembly.
10. The exact positioning of the caster, in
will determine whether the finished speaker will stand upstraight. The type of floor the system sits on
will ultimately determine how far the casters should be threaded in. On a hardwood, tile or cement
floor. the casters Will need to be threaded in all the way. On a carpeted floor,
need to be left showing. depending on the carpet pile. Once the proper adjustments have been
made, the stopnut should be securely tightened against the flat washer. Most likely some
adjustmentwill be necessary after the system has been stood up. At which time the heightcan be
adjusted and the stopnut secured, once the correct setting is achieved. The correct setting is thot
which leaves the system perpendicular to the floor. Once achieved, use a 7 / 1 6 wrench or pliers to
tighten the stopnut against the flat washer.
WARNING: T h e casterwill not support the entire weight of the finished speakersystem. Thecastersare
not designed to be used like
guide the assembled speaker as it is "shuffled" across the floor.
11, Position the assembled speaker system in the room, such that it i s approximately three feet from the
back wail and a minimum of
position. Plug the line cord into an always live outlet. Set the high frequency balance control to the
"0' position for your initial setting Connect speaker terminals to amplifier, making sure to maintain
proper"phase". i.e. plus(+) terminalofamplifierwired to plus(+) terminal of the speaker and. minus
(-)to minus(-).
12.
Repeat the above procedure for the other speaker system.
NOTE Due to the break-in requirementoftheelectrostatic portionofthe speakersystem, the firstfewdays
of playing time will produce sonic improvement and an increase
Do
not yet tighten the lock-nut to secure caster. Repeat for other
terms of how much of the stemis screwed into the wood
a
"dolly" for moving the assembled system. but rather are intended to
two
feet from the side wall, angled towards the center listening
5
1/2"
to of thread
'/A''
in
efficiency.
block,
may