Acoustat Two/M Owners Manual And Assemly Instruction page 6

of
not to pinch any
fit under the U-shaped flap on the insulator plate.
5. Now the woofer box i s to be placed into the opening on the back of the speaker. (The box i s rather
heavy and you may wish to have an assistant help you lift the assembly into place.) Carefully lift the
boxupofftheframeand placeitsquarely intotheopening atthe bottomof the speakers frame. Be
sure not to pinch any wires from the three wire groups as the box is set into place. (Be careful Where
you grasp the box when lifting it. i.e. don't put
box!!)
6. Select the two short(1/2") screws from the hardware kit. Using aflat bladescrewdriver, install these two
screws through the two metal straps atthe topof the box and into thetwothreaded holeson the top
of the box.
N O T E : If the holesdo not line up, the metal strap can be easily moved to align with the hole. Simply
tap the strap with the screwdriver in the direction
screws securely.
7. Carefully grasp the topof thesystemandstand theentireassembly upright.
Will stand, leaning on the lower/back edge of the woofer box. Now, C A R E F U L L Y lean entire assembly
back until the top of the speaker rests on therearwalland the back/bottom edge of the woofer box
rests on the floor.This will expose the three holeson the bottomof thespeakerframe. where the base
is to be installed. Select the three long (2 1/2') screws and three small washers from the hardware kit.
Select one of the bases from the base box.
8. lnstall a small flat washer on each long screw. Insert one of these assemblies through the bottom right
hole on the base (the hole on the side of the base with the Acoustat nameplate), Align this screw with
the right-most hole on the bottom of the speaker's frame. Using a flat blade screwdriver, screw
L O O S E L Y intoframe. Select another screw/washer assembly and lift leftsideof base until hole in base
aligns with left hole
frame. Select last screw/washer assembly and install in center base/frame holesas before Once the
three screw/washer assemblies have been screwed loosely into theframe. align the rear edge of the
base with the rear edge of the speakers bottom and tighten all three screws VERY S E C U R E L Y .
WARNING Thecasterwill not supporttheentireweightof thefinished speaker system.The casters are
not designed to be used like
guide the assembled speaker as it is "shuffled" across the floor.
the wires under the plastic. When properly assembled. the wire groups should ALL
the speakers frame, insert screw/washer assembly and screw LOOSELY into
in
a
"dolly" for moving the assembled system but rather are intended to
your hand through the woofer on the bottom of the
necessary
to align with woofer box hole. Tighten
4
At thispoint, thesystem