Introduction; Registration Cards; Fuses; For Models Two/M & Three/M - Acoustat Two/M Owners Manual And Assemly Instruction

INTRODUCTION

Congratulations on your purchase of the worlds finest loudspeaker, the Acoustat Modular Hybrid
electrostatic with Magne-Kinetic Interface'. Please review the entlre owner' s manual before you begin to
assemble your new speakers to assure you of reaching the speaker's full sonic potential. When
assembled, placed correctly in the room, and used with the proper electronics, the Acoustat electrostatic
loudspeakers will provide you with years of listening enjoyment.
PLEASE NOTE: The speakers require several hours of playing time before their full efficiency can be realized

REGISTRATION CARDS

Please complete and return the enclosed purchase registration card within ten days of purchase of your
new speakers. Thi s card does not determine your eligibilityfor waranty but will allow Acoustat to inform
you of updates and other product news that would be of interest to speaker owners. Any additional
information you provide will aid the Acoustat Corporation in continuing to bring music lovers everywhere
the finest audio components available today.
PAC KAGl I N G
SAVE ALL PACKAGING MATERIALS !
equipment, and must be properly cartoned whenever shipment
packaging materials will insure safe transport If lost or damaged, replacement packaging materials
may obtained from the Acoustat Corporation at a nominal charge.
be

FUSES

Acoustat speakers Models Two/M and Three/M and Models Two/MH and Three/MH utilize slo-blo type
fuse(s) in the audio signal path. The ModelsTw/M and Three/M with Magne-Kinetic 121 Interface,
Models Tw/MH and Three/MH with MagneKinetic 131 Interface utilize 3 amp slo-blow fuse. When
replacing fuse(s) only those of similar value and type can be used or the warranty may become invalid.
ASSEMB LY INSTRUCTIONS
For Models Two/M & Three/M
PLEASE READ COMPLETELY BEFORE YOU BEGIN TO ASSEMBLE YOUR SPEAKER SYSTEM!
1, Lay the speaker face up on the floor. CAREFULLY and SLOWLY! Dropping the speaker could rupture
the diaphragm with trapped air.
2. Remove the three screws from the bottom of the speaker system. The screws are 2-1/2" in length,
each with a flat washer. Set them aside.
3. Remove oneofthe bases from the base box. Place the base against the bottom of the speaker. such
that the front/top(name plate is on thefront-right handcornerof the base) of the base faces up, and
the three holes line up with the three holes in the bottom of the speaker. Start all three long
screw/washer assemblies (through the base holes) into the speakers frame, DO N O T T I G H T E N
4. Adjust the base so that there arof the base is flush with the rear of the frame. lighten the three screws
securely.
Your
Acoustat electrostatic loudspeakers are finely crafted pieces of
1
is necessary. O N L Y the original
.
and