Cleaning; Removal Of Interface For All Models; High Frequency Balance - Acoustat ONE Owner's Manual And Assembly Instructions

CLEANING

Speakercloth may be cteoned with anycommercial
be used with polyester knit
interface
discharge the panels:
UNPLUG interface from the
amplifier.
2. Remove the four
provided.
3. the interface unit from
the interface unit on the Boor directly behind the speaker, being careful
4.
the three wire groups
Remove the center RED pin plug. Hold the wire an inch behind the pin and
5.
PLUG!
NOT GRAB
Loosen the
6.
W A R N I N G : High static
procedures will result
-
FREQUENCY BALANCE CONTROL
frequency balance
This
acoustics.
Follow the
diagram locate the high frequencybatance resistor in the interface assembty. Loosen the
center tap and
adjustment, tap
that
Use cleaner such as K2R for
from the speaker, the following procedure is necessary to
be removed
head screws
side
o r
strain the wiring harness.
Touch
thumbscrews and remove the hooks.
are present
in
an annoying but
is
at the
level can adjusted for
be
for "REMOVAL O F INTERFACE at fhe end of
o r right, according to the diagram for increase or decrease. After
NOTE
are
IDENTICALLY.
outlet and
secure the main interface assembly, using the
brackets
to either the BLUE or WHITE
in
the charged panel.
shack.
for
optimum
situations
optimum performance and stereo imaging be SURE
checked with an ohmmeter.
oranycleaner designedfo
concenffated spots.
the speaker leads from the
not to unpfug
pull. DO
on the circuit
to fallow these
a
room
in
fhe following manner.
manual. Referring to