Adjust Clock; Operating Instructions - Axis AX1500 Installation Manual

OPERATING INSTRUCTIONS

POWER ON/OFF
1.
Press POWER ON button to power the unit. Press and hold
MUTE
Press this button briefly to select MUTE. To restore sound, press again.
2. SELECT
3. VOLUME UP/DOWN
Turning the VOL knob to right or left (3) to control the VOLUME. To select other functions, hold
the VOL knob down until the desired functions is shown on the display. Figure 1 shows how
control functions are selected using the VOL knob.
1
1. VOLUME
These buttons can be used to adjust the BASS, TREBLE, BALANCE and FADER.
Press and hold VOL knob to adjust below function:
2 sec.
SEL I-VOL
I-VOL
Turn the VOL knob to set the volume level, with which the device is to be set when turned on.

ADJUST CLOCK

Turn VOL knob to right for hours and left for minutes.
DISPLAY
Time displays
STEREO/MONO
When FM signal is weak or distorted, reception may improve by turn VOL knob to select MONO.
LOCAL
"Local" position in areas with strong signal will cause radio to only tune strong stations. During
manual tuning (LOC appears). Select Distant position in areas with weak signal. Turn the "VOL"
knob to set the LOCAL ON/OFF.
EQ MODE
Turn VOL knob to select one of the settings EQ OFF/CLASS/ROCK/POP/EQ FLAT.
4. PRESET STATIONS (1,2,3,4,5,6)
(A) RADIO MODE:
Six numbered preset buttons store and recall stations for each band.
Storing a station:
1. Select a band (if needed)
2. Select a station
3. Hold a preset button longer than one second. Preset numbers appear on the display when station
is saved.
2
SEL SEL
Fig. 1 Selection of sound control functions
2. BASS
SEL ADJ CLOCK SEL
to turn off.
3 4
SEL
3. TREBLE 4. BALANCE
DISP SEL STEREO
5
5
SEL SEL
5. FADER
SEL LOC OFF SEL EQ OFF