Clearing The Assignment Of Button Inputs To Actuator Channels - HomeMatic HMW-IO-4-FM Installation And Operating Manual

If a button that was taught for an actuator is
taught for the same actuator again, the old
assignment is overwritten.
7.2 Clearing the assignment of button
inputs to actuator channels
Clearing the assignment of a button input and
actuator (channel)
• Press the programming button of the actuator
(channel) that you want to clear the assignment
for until the respective channel LED switches
from slow flashing to quickly flashing (after
approx. 6 seconds).
• Release the button. The module is now in
delete mode.
• Now, press a button on the button input of
a module for which you want to clear the
assignment. The channel LED on the actuator
goes dark and the assignment is deleted, the
actuator (channel) is no longer actuated on this
switch input.
• Test the setting by actuating a button on the
deleted button input, the actuator (channel)
should not react.
29