Blaupunkt LS 181 Instruction Manual page 39

LS 181
The only means of completely disconnecting the product from the power supply is
24.
by removing the power cord from the wall outlet or the product. The wall outlet or
the power cord entry to the product must remain freely accessible at all times while
the product is in use.
25. Try to install the product near a wall socket or extension cord and shall be easily
accessible.
26. The highest environmental temperature suitable for this product is 35°C.
27. ESD hints - The normal function of the product may be disturbed by strong Electro-
Magnetic Interference. If so, simply reset the product to resume normal operation
by following the instruction manual. In case the function could not resume, please
use the product in other location.
28. Battery
1).
The batteries must not be exposed to excessive heat such as sunshine, fire or
the like.
The batteries should be drawn to the environmental aspects of battery
2).
disposal.
3). Battery usage CAUTION-to prevent battery leakage which may result in body
injuries, property damage, or damage to the apparatus:
Install all batteries correctly, + and – as marked on the apparatus.
Do not mix batteries (old and new or carbon and alkaline, etc.)
Remove batteries when the unit is not used for a long time.
ERP2 - (Energy Related Products) note
This product with ecodesign complies with the stage 2 requirements of Commission
Regulation (EC) NO. 1275/2008 implementing Directive 2009/125/EC regard to standby
and off mode electric power consumption of electronic household and office equipment.
After 60 minutes without any audio input, the device will automatically switch into
standby mode. Follow up the instruction manual to resume the operation.
Important note:
This device is equipped with an energy saving mode: if no signal is given during 60
minutes the device will switch automatically into standby mode in order to save energy
(ERP 2 standard). Please note that low volume setting in the audio source may be
recognized as "no audio signal": this will affect the capability of signal detection from the
device and can also originate an automatic switch into standby mode. If this happens
please reactivate the audio signal transmission or increase the volume setting on the
audio source player (MP3 player, etc.), in order to resume playback. Please contact the
local service center if the problem remains.
®
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by us is under license. Other trademarks and trade names
are those of their respective owners.
38