Troubleshooting - Metabo KNS 18 LTX 150 Original Instructions Manual

en ENGLISH
7.1 Positioning the accessory
See illustration c, page 2.
- The two sides of the support flange (14) are
different: Place the support flange (14) around the
spindle (15) in such a way that the large collar
diameter which corresponds to the accessory (13)
is facing upwards.
- Place the accessory (13) on the support flange
(14). The accessory must lay flat on the
supporting flange.
7.2 Tightening/loosening the clamping nut
Securing the clamping nut (12):
See illustration d on page 2.
The 2 sides of the clamping nut (12) are different.
Screw the clamping nut onto the spindle (15) as
follows:
A
9
B
9
- A) In the case of thick (6 mm) accessories:
The collar of the clamping nut (12) faces
downwards so that the clamping nut can be
attached securely to the spindle.
B) In the case of thin (3 mm) accessories:
The collar of the clamping nut (12) faces upwards
so that the thin accessory can be clamped
securely.
- Lock the spindle (15) using the Allen key (17).
Tighten the clamping nut (12) by turning it
clockwise using the 2-hole spanner (18) (see
illustration c, page 2).
Releasing the clamping nut:
- Lock the spindle using the Allen key (17). Remove
the clamping nut (12) by turning it
anticlockwise using the 2-hole spanner (18)
(see illustration b, page 2).
8. Use
8.1 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When switching
the machine on and off, keep it away from dust
deposits. After switching off the machine, only place
it down when the motor has come to a standstill.
Avoid switching on the machine accidentally:
always switch it off when the battery pack is
removed from the machine.
14
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand in a
safe position and concentrate.
0
Switching on: Push the slide switch (5) forward.
For continuous operation, flip the switch down until
it locks in place.
Switching off: Press the rear end of the slide
switch (5) and release.
8.2 Working instructions
Press down lightly on the machine and move over
and back across the surface.
9. Cleaning
Motor cleaning: blow compressed air through the
rear ventilation slots of the machine regularly,
frequently and thoroughly. Here, the machine must
be held firmly.

10. Troubleshooting

The electronic signal display (6) lights up
and the load speed decreases. The
temperature is too high! Run the machine in
idling until the electronics signal indicator switches
off.
The electronic signal display (6) flashes
and the machine does not start. The restart
protection is active.
The machine will not start if the battery pack is
inserted while the machine is on. Switch the
machine off and on again.
11. Accessories
Use only genuine Metabo accessories.
Use only accessories which fulfil the requirements
and specifications listed in these operating instruc-
tions.
See page 4.
A Chargers
B Battery packs with different capacities.
Use battery packs only with voltage suitable for
your power tool.
C Nylon web compact disk
D File for profiling nylon web compact disks
E Sanding paper strips for file
For a complete range of accessories, see
www.metabo.com or the main catalogue.
12. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
8
I