Oxy Heli oxy2 Instruction Manual page 30

4 x M1.6x5 - Hex
Cap Screw
OXY0552 - Leveler
(Box 2/Bag 4)
page 30
2 x OXY0525-
1.6X3.5X0.5 Washer
Tail Push Rod Assembly
(Box 3/Bag 1)
4 x M1.6x5 - Hex Cap Screw
Chapter 16: Tail Servo Installation
Top Heli View
Bottom Heli View
Arm position with
centered Rudder stick.
Maximun Tail Servo Size Note:
Max 12mm
With Rudder Stick centered
and the Tail Servo Arm in the
center position, adjust the
Tail Push Rod length until the
Tail Bell Crank and Tail Case
Plate are parallel as shown.
The Oxy 2 Tail System has
approximately 3.5 of counter
torque with the Tail Bell Crank
set per instructions.