Oxy Heli oxy2 Instruction Manual page 24

Main Rotor Assembly
(Box 1-1/Bag 5)
OXY0447 -
DFC Pin Screw
DFC Arm
Swash Plate Assembly
(Box 1-1/Bag 6)
5 x OXY0521-Linkage
ball 3x1.5mm
page 24
OXY0530 -
2X4X4.4 Bushing
OXY0454-Anti
Rotation Pin
Chapter 11: Main Rotor Assembly
Flat surface
DFC Arm are not symmetrical.
Flat surface faced to Screw.
Step faced to Main Grip.
Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly.
Once you finish assembly, ensure the DFC
Arms can rotate without friction. If the DFC
Arms are assembled correctly, rotation
should be smooth and without friction. In
case of any friction, recheck each
component and re-assembly as necessary.
OXY0020-M1.2x2
Special Screw
Center Ball
Lower and Upper
Swash Plate
Important Note:
this part, for tuning reasions,
comes factory pre assembled,
it ready to use.
Important Note:
This part comes pre assembled WITHOUT
thread lock. Follow the instruction for final
assembly.
Swivel Ball Note:
The Swivel Ball is pre-assembled with a
precise fitting. When new, the Swash Plate
center ball will have a little friction. After a
few flights and "break-in" it will come smooth,
keeping the best precision without play.
Stepped surface